-1: Inconsistent command line options when running from the command line.
1: Conditioner::getProbe: probe number out of range.
2: Conditioner::getProbe: Accessing position of probe that doesn't know its
position yet.
3: Conditioner::setProbe: probe number out of range
4: Conditioner::setProbe: Setting probe that already had a position.
5: Calibrator::readRawData(): Cannot open input file with raw data
6: Calibrator::readRawData: Unexpected end of input file with raw
data.
7: Cannot open output file dzdat[n].dat. Disk full? Non-existent directory?
31: Conditioner::updateProbe: probe number out of range
60: Calibrator::readRawData: Unexpected end of input file during
reading of data.
999: Side::getNormal: Less than three points on this side, can't
calculate normal.
1000+n: Calibrator::calibrate(): Cannot open input file result[n].out
or dzdat[n].dat with data from/about conditioner [n]
1100: Trying to use conditioner data that doesn't exist. The
calib. datafile was checked to exist, so this is an impossible
error. Therefore abort. Time for some debugging.
1234: In HallProbe::applyStripRotation: Changed field strength! Bug in code.
1236: HallProbe::applyStripRotation: Unexpected angle of strip after
rotation.
2001: Calibrator::ReadSurveyData: Unexpected end of file aligndat/surveydata_strips.dat
2002: Calibrator::ReadSurveyData: Unknown conditioner label
2003: Calibrator::ReadSurveyData: Unexpected end of file aligndat/surveydata_mountingblocks.dat
2004: Calibrator::processBlockPointLabel: Unknown conditioner label.
2006: Calibrator::readSurveyData: Cannot open survey-datafile aligndat/surveydata_strips.dat
2008: Calibrator::readRawData: Unexpected line found at end of
measurement. Expecting "<----" or "STOP".
2009: Calibrator::readSurveyData: Cannot open survey file aligndat/surveydata_mountingblocks.dat
2010: Calibrator::applyStripAlignment: Cannot open file with strip
alignments.
2011: Calibrator::applyStripAlignment: Unexpected EOF when reading
header of file with strip alignments.
2012: Calibrator::applyStripAlignment: Unexpected EOF when reading
data in file with strip alignments.
2013: Calibrator::applyStripAlignment: Not all heads on all conditioners
know there survey data yet.
3010: MountingBlock::getProbePoints: Not all sides initialized
(i.e. survey points set).
3011: MountingBlock::getProbePoints: Not all sides have 3 points or
more.
3012: MountingBlock::set_orientation can't determine the inner side. The
inner side is the side of the block facing towards the beam
direction.
3013: MountingBlock:set_orientation can't determin the phi side. The phi
side is the side facing in the direction of the phi-unit vector.
4001: Point::normalizeVec: After normalization, length is not 1.

4006: HallProbe::getNormal: Less than 3 points on this probe - unable
to calculate plane for normal vector.
4007: "HallProbe::getZaxis: Less than 4 points on this probe - unable
to calculate Z-axis.
4008: HallProbe::align: Internal B field not set
4009: HallProbe::getB_D0: Probe not aligned (i.e. aligment data not
set for this probe yet)
4010: HallProbe::align: Alignment has changed B field strength -
this means there is a bug!