This appendix lists the kinematic parameters of all lepton + jets
candidate events which pass the loose cuts, plus the results of the
mass fit. Each event is identified by a run and event number. The
and 
values for the event are also listed. If the
event also passes the standard cuts, the event number is followed by an
asterisk (
). Next, the lepton, missing 
, jets, and the tag
muon (if present) are listed. All objects are dumped as a four
vector, plus the (
), 
, and 
values. Jets are R = 0.3 cone, with the out-of-cone corrections
applied. Tagged jets are listed twice, both with and without the
correction for the tagging muon (the latter is indicated by a dagger
(
)). All jets with 
and 
< 2.5 are
listed, although only the first four are used for mass fitting.
Following the dump of the object four-vectors is another table giving
the result of the mass fits for that event. Up to three fits are
listed, giving the fitted mass (
), 
, and the jet
permutation used (the letters correspond to the first four jets;
associated with leptonic top,
associated with hadronic top,
hadronic W). The -weighted average is also
listed at the bottom. Fits with 
are not listed. For
tagged candidates, only the fits which properly assign the tagged jet
as a b are listed.
Due to an implementation error, a cut which was intended to reject
before fitting jet permutations in which there was a large difference between
the two top masses was actually rejecting permutations for which
the smallest solution for the z-component of the neutrino
momentum was large compared to the 
. This is noted in the few
cases where this affects the results for a candidate event.
Note, however, that since the procedure was applied consistently
to both data and Monte Carlo, this does not affect the reliability
of the final result.