switch from
current default
ResolutionSmear_Option:     3
which uses hard-coded parameters to
ResolutionSmear_Option:     2
to to be able to set parameters in parameters.rc 

Sampling_CC:      0.30
Constant_CC:      0.0235
Noise_CC:         0.29
Sampling_CC1:     0.1633
Sampling_CC2:     -10.0


smearoption2, DEFAULT resolution, full fz range [1.0, 2.2] :
par0 (scale)0.925355 0.00180009
par1 (offset)1.2787 0.0229243
corr = 0.170

smearoption2, DEFAULT resolution, restricted fz range [1.2, 2.0] :
par0 (scale)0.922693 0.00161917
par1 (offset)1.29746 0.0233027
corr = 0.361

smearoption2, resolution DOWN by 20%, full fz range [1.0, 2.2] :
par0 (scale)0.949158 0.000554608
par1 (offset)1.13609 0.0191768
corr = -0.040

smearoption2, resolution DOWN by 20%, restricted fz range [1.2, 2.0] :
par0 (scale)0.937226 0.00107839
par1 (offset)1.18972 0.0179147
corr = -0.068

smearoption2, resolution UP by 20%, full fz range [1.0, 2.2] :
fitter crashed 

smearoption2, resolution UP by 20%, restricted fz range [1.2, 2.0] :
fitter crashed